To connect a DIRECTV remote to a Vizio TV, follow these steps:
1. Turn on Your TV: Make sure your Vizio TV is powered on.
2. Turn on Your DIRECTV Receiver: Press the power button on your DIRECTV receiver to turn it on.
3. Enter Pairing Mode on the DIRECTV Remote:
– Hold down the “Mute” and “Select” buttons simultaneously on the DIRECTV remote for about 3 seconds. The red indicator light at the top of the remote will blink twice and remain on.
4. Program the Remote:
– On the remote, press and release the “TV” button. The red light will blink once and then stay on.
– Enter the Vizio TV’s 5-digit code. To find the code, you can either refer to the DIRECTV remote’s user manual or use the code search method (explained below). After entering the code, the red light will turn off.
5. Test the Remote:
– Try adjusting the volume or turning the TV on/off using the remote. If it works, the remote is successfully paired.
6. If the Code Doesn’t Work:
– If the code doesn’t work, you can try the Code Search method:
– With the remote in TV mode (TV button lit), press and hold the “Select” and “Mute” buttons until the red indicator blinks twice and stays on.
– Release both buttons.
– Press and release the “Enter” button. The remote will begin searching for a compatible code for your TV. This may take a few minutes. Once the correct code is found, the red light will turn off.
7. Troubleshooting:
– If the remote doesn’t work after pairing, repeat the steps, ensuring the correct code is entered.
– If you cannot find the right code, you may also check DIRECTV’s online resources for updated codes or try the automatic code search method.
By following these steps, you should be able to control your Vizio TV using your DIRECTV remote.
